Voyager 2.2 Tent Pitching Instructions

The classic Voyager but bigger. Read the Voyager 2.2 tent pitching instructions below:

1. Lay out the inner tent.
2. Carefully assemble each of the 3 poles. Ensure all the joints are fully inserted.
3. Using the diagram below lay the poles over the inner tent as follows:
   – Pole 1 (blue) diagonally between A and B, making sure the pole locates through the short sleeve where the blue and red poles cross.
   – Pole 2 (blue) diagonally between C and D, making sure the pole locates through the short sleeve where the blue and red poles cross.
   – Pole 3 (red) between E and F, making sure the pole locates through the holes where the blue and red poles cross, one on either side of the inner tent.
4. Insert a pole-end into the outermost eyelet of each inner tent eyelet tape. The tapes are colour-coded to match the relevant pole.
5. Clip the inner tent clips to the poles.
6. Throw the flysheet over the inner tent. Hook flysheet eyelet tabs to pole end-tips.
7. Insert each pole-end into the corresponding eyelet tape on the hem of the flysheet. Note the eyelet tapes are colour-coded to match the relevant pole.
8. Peg out the tent.
9. Remember to adjust the flysheet tension as conditions alter, as the flysheet will tighten in strong sunlight and slacken if it gets wet.

The Voyager 2.2 is supplied with the following:

• 3 x alloy poles (1 x red, 2 x blue)
• 16 x Alloy pegs

The Voyager 2.2 has been discontinued. We’d recommend the Voyager.

Voyager 2.2 Tent Pitching Video